Savjet za trosistemski zvučnik novije generacije! - YU-MIDI Muzički Portal

ibanez · 13.11.2013, 11:34

Da li je pojacalo snage 2 x 500 w na 8 ohm ili na 4 ohm.
To je bitno za bilo kakvu preporuku.Bilo bi dobro kada bi
napisao i tacan model pojacala.Pozz

b.o.Y.c.h. ČK · 13.11.2013, 12:35

Pa pojačalo koristim sa mixera Yamaha EMX 5000, mislim da radi na 4 ohma.
Usput, imam neku priliku kupiti dynacord D12-3, pa neznam dali bi to sve zajedno dobro funkcioniralo..

Evo karakteristike tog D12-3:
Cabinet: Full-Range
Configuration: Passive 3-Way
Nominal impedance: 8 Ohms
Rated power RMS: 350 Watts
Program power: 700 Watts
Peak power: 1400 Watts
SPL 2,83 V / 1m 1W / 8 Ohm: 100 dB
Max. SPL 1m (calculated with peak power): 131 dB
Frequency range ( -10dB ) Full range: 70 Hz - 20kHz
Coverage angle 1 kHz -6dB: 120° Conical
Coverage angle 10kHz -6dB: 90° * 50°
Passive crossover frequency: 700Hz, 4kHz
Voice coil tracking protection: Yes
Component HIGH: Electro-Voice DH-3
Component MID: DYNACORD DND 6120 Neodymium
Component LOW: Electro-Voice DL12BFH
Connectors:
Full-Range1+, 1-
Wired through2+, 2-

MarjanMilosevic · 14.11.2013, 14:23

Kod tog Dynacorda cesto crkava mid. Tako da ja bih ga zaobiso jer je zamena istog oko 180 eura.

13.11.2013, 11:34	#1
ibanez Žarko Brlja Registrovan/a dana: 01.04.2009 Mjesto: Titel Godina: 64 Postovi: 122 Downloads: 135 Uploads: 60 Rekao HVALA: 7 Zahvalili mu 28 puta u 27 Postova Instrumenti: Gitara, aranzer modul Interesi: Kao sav normalan svet	Da li je pojacalo snage 2 x 500 w na 8 ohm ili na 4 ohm. To je bitno za bilo kakvu preporuku.Bilo bi dobro kada bi napisao i tacan model pojacala.Pozz __________________ Imam godina - nemam novaca,a i da imam... sta kupiti?

13.11.2013, 12:35	#2
b.o.Y.c.h. ČK Odomaćeni član Registrovan/a dana: 25.04.2007 Mjesto: Međimurje, Bayern Godina: 37 Postovi: 509 Downloads: 686 Uploads: 13 Rekao HVALA: 124 Zahvalili mu 44 puta u 44 Postova Instrumenti: Genos, Scandalli, Bugari Gold, Hohner Bravo III Interesi: Skupljanje salveta	Pa pojačalo koristim sa mixera Yamaha EMX 5000, mislim da radi na 4 ohma. Usput, imam neku priliku kupiti dynacord D12-3, pa neznam dali bi to sve zajedno dobro funkcioniralo.. Evo karakteristike tog D12-3: Cabinet: Full-Range Configuration: Passive 3-Way Nominal impedance: 8 Ohms Rated power RMS: 350 Watts Program power: 700 Watts Peak power: 1400 Watts SPL 2,83 V / 1m 1W / 8 Ohm: 100 dB Max. SPL 1m (calculated with peak power): 131 dB Frequency range ( -10dB ) Full range: 70 Hz - 20kHz Coverage angle 1 kHz -6dB: 120° Conical Coverage angle 10kHz -6dB: 90° * 50° Passive crossover frequency: 700Hz, 4kHz Voice coil tracking protection: Yes Component HIGH: Electro-Voice DH-3 Component MID: DYNACORD DND 6120 Neodymium Component LOW: Electro-Voice DL12BFH Connectors: Full-Range1+, 1- Wired through2+, 2- __________________ https://www.youtube.com/user/bcirkvencic/videos

Alati tema
Kako izgleda kad se tampa Pošalji stranicu prijateljima na E-mail
Display Modes
Promeni na Linearni mod Hybrid Mode Switch to Threaded Mode

14.11.2013, 14:23	#3
MarjanMilosevic Odomaćeni član Registrovan/a dana: 05.10.2011 Mjesto: Skopje Postovi: 594 Downloads: 3 Uploads: 0 Rekao HVALA: 4 Zahvalili mu 56 puta u 49 Postova	Kod tog Dynacorda cesto crkava mid. Tako da ja bih ga zaobiso jer je zamena istog oko 180 eura.